The Bluetooth Shield integrates a Serial Bluetooth module. It can be easily used with Arduino for transparent wireless serial communication. You can choose two pins from Arduino D0 to D7 as Software Serial Ports to communicate with Bluetooth Shield (D0 and D1 is Hardware Serial Port). Download: Product Wiki Features Arduino compatibleUp to 10m communication distance for line-of-sight communicationUART interface (TTL) with programmable baud rate (SPP firmware installed)Default Baud rate: 38400, Data bits: 8, Stop bit: 1, Parity: No parityDefault PINCODE:”0000”A full set of configuration commandsOn board PCB Antenna [edit]Specification ItemMinTypicalMaxUnit Voltage 2.8 3.3 3.5 VDC Current 3 / 100 mA Communication Distance(in house) / / 10 m Protocol Bluetooth V2.0 with SPP firmware / Interface Uart Serial Port(TTL) / Supported Baudrate 9600, 19200, 38400, 57600, 115200, 230400, 460800 bps Dimension 57.4x45.3x19.4 mm Net Weight 10±2 g [edit]Quick Test [edit]Host-Slave mode: Communication between two different Bluetooth shields [Note: in the following sample code, the soft serial has a baud rate of 38400, which makes the code a little bit not stable, if you see failure, please try multiple times].Take one Bluetooth shield and do the following: Select the Bluetooth shield communication port using jumpers: BT_RX is connected to D6 of Digital-6, BT_TX is connected to Digital-7. Move the mode selection switch to lower position so that Bluetooth module will enter into AT command mode. Install Bluetooth shield on the Arduino Uno,and plung Arduino into PC, LED D1 on Bluetooth shield will start blinking.Copy and paste the following sample code and download to Arduino: #include #define RxD 7 #define TxD 6 SoftwareSerial BlueToothSeria
I**N
Definitely not plug and play.
I'm sure it's a good shield. Maybe I was expecting too much. I wanted something I could plug onto my UNO, upload firmware and communicate with it through my laptop Bluetooth. Not so. I couldn't find anything online that made it easy for me to operate. It looks like I have to be more Arduino code literate to make it do what I want it to do.
T**N
more example sketches
Could have a few more example sketches, I have only been able to link it once. Most likely operator/programmer error.
A**R
Four Stars
its a good quality product
J**B
I purchased three of these for planned projects and have so far wasted an entire weekend trying to make any of them ...
There is a severe lack of documentation for how to use this product. I purchased three of these for planned projects and have so far wasted an entire weekend trying to make any of them work. If you are looking for a bluetooth shield, buy a different product.
ترست بايلوت
منذ شهر
منذ 5 أيام
