A bike computer for a turbo trainer HAS to be attached to the rear wheel for obvious reasons. Most wireless computers don't work at distances greater than 60cm. Most wired computers don't have a wire long enough to reach the rear wheel as they are designed for FRONT WHEEL installation.This computer is rain proof but WON'T withstand prolonged soakingLCD Display BATTERY SUPPLIEDFunctionsSPD Current SpeedODO- Odometer(0-9999km/m)Trip DistanceMXS-Maximum SpeedAVS-Average SpeedCLK-Clock(12/24hr)StopwatchSCAN Cycles through the different readoutsMetric/ImperialAuto On/OffSignal Interference ResistanceBack LightComputer Battery Installation Remove the battery cover from the bottom of the computer by using a coin / install CR2032 battery supplied with the positive (+) pole facing the battery cover and replace the cover. Should the LCD show irregular figures, take out the battery and reinstall it.
S**U
Good purchase for turbo trainer bike
I have used this on my turbo trainer mounted bike. The display is a little small, but once you get used to the read out there is no difficulty in reading (even for a 51yr old!). The back light gives sufficient light to read the display in the gloom.I found the set up very easy, and accompanying instructions helpful. The only tweak I had to do was move the sensor towards the spoke mounted magnet, to minimise the gap between to enable a secure signal (I placed a small pice of cardboard behind the sensor prior to clipping to the rear frame). I guess frame styles can give wider or smaller gaps.Don’t expect all the whistles & bells with this, however In my view this is an excellent peace of kit for any static or mobile bike and at a very reasonable price too.
C**Y
... LATER FINALLY CABLE CLIPS YOU GET WITH IT ARE USELESS WENT OUT SHOPPING BROUGHT MY OWN AND A ROLL ...
Be prepared for a challenge trying to get this product to work on your bike trainer ONE AND A HALF HOURS LATER FINALLY CABLE CLIPS YOU GET WITH IT ARE USELESS WENT OUT SHOPPING BROUGHT MY OWN AND A ROLL OF BLACK TAPE THE GAP FROM SENSOR TO MAGNET AS TO BE 5 MM AND 10 MM NO MORE
R**N
wont fit correctly on my spesh allez elite
i normally have five star reviews this is not the product as such it just wont fit on my spesh as rear seat stays are curved and try as I might it will not position properly to pick up off the sensor very disappointed as I wanted to record info on the turbo if this fits your bike its perfect
S**H
Good overall, slightly confusing
A little confusing to use to be honest despite using instructions. Good overall but confusing.
A**R
Excellent qaulity
No problems as discribed
P**9
Five Stars
Great product, does the job for my Turbo trainer
N**N
Not impressed .
This is not suitable for a turbo trainer, as it is impossible to get the correct gap (5-10mm) for the sensor to work on the back wheel.
M**G
Do not buy for 29inch Mountain Bikes
I bought this to work on a 29 inch Mountain Bike! There is no setting in the instructions for 29inch or contact details to find out if there actually is a setting so useless for me.
Trustpilot
1 week ago
3 days ago