Loud Speaker Repair Glue Foam Side Dust Cap Rubber Edge Cone Basin Strong Adhesive 50ML/1.68 fl.oz (1)

I had to reattach the outer rings to a couple of cheap Pyle speakers I was just testing for size. I was considering some pricier PVA adhesive from Simply Speakers but found this instead. The low mess applicator tip is built in to the tube and came in very handy. It seems to be doing the job, holding secure. I will be using this again.

I used this to repair/re-foam 6 speakers since I purchased it. The first set was a pair of old Advent bookshelf speakers, I used them for a while before using the glue on 2 pair of vintage Polk audio speakers. Once I sourced the foam, I removed and cleaned the surface area and followed the directions for speaker re-foam I found online. I use the small set of Polk bookshelf speakers daily for months and they are holding up well. The other set of speakers were 1987 Polk Audio Monitor 10b's that needed foam on the woofers and passive subs. I followed the same process as before and they work great. It's been about a year with no problems. I give these speakers the beans regularly as part of my vintage audio system and 250w amp. They're holding strong so, I'd say this glue is quite good.

Used to repair an antique radio speaker that was not worth having professionally refurbished. Used to seal some small tears in the cone, reglue detached spider to the frame, and (with some coffee filter as "stitching" material) to seal up the large incision made around the voice coil to access the spider. I wouldn't have attempted such a thing unless it was a last ditch effort with nothing to lose.Product is easy to apply, laying down a nice bead through the fine applicator tip. I love that the cap has a needle that inserts into the applicator tip to prevent clogs. For the more substantial patch-up work, I used a small hobby paint brush to apply over the coffee filter material. It was humid here at the time of application, and the glue was still just a bit tacky nearly 24 hours after application in the areas where it had been applied most liberally, so I gave it a little extra time. The product has only a minimal smell.I can't say yet if this fix is going to stand the test of time, but I can say that I now how have a useful speaker and radio instead of having to scour the forums for a spare out of someone's old junker. And this tube was a lot less expensive, and I have plenty left for my next repair. I couldn't be happier!

Used them to re-foam a pair of old Realistic 77 speakers. Started to hold in about 1/2 hour and full cure in 24 hours. Very easy to use. The glue flowed easily and the cap with a pin sealed the tube for later use.

Repaired three Sonos speakers I was about to throw out. I use them outdoors, so the speakers had some cracks in them open them up repair them with his glue. They sound like brand new Speakers saved myself a ton of money.

The edge of my 12” kicker subwoofer was split open in a few locations. From a few small 1” rips to a big 6” split along the outer rim across then about another inch along the inner rim. I used this product as instructed and the sub works as good as new. It’s held up for about 6 months now counting. Highly recommend

seems to be a pretty good glue. glued rubber surround cone and metal frame. the needle nose is great feature and keeps the tip clean for next time use. havent used speakers yet but looks like the will hold .

work's Great